Witura WT-9001 IP65 Manuel d'utilisateur télécharger pdf (Page 25)

WT-9001 IP65 GSM Remote Control And Alarm System

WT-9001 IP65 – USER MANUAL – Rev. 3.4 – Technical Support: technical@witura.com

To check the signal strength (0-31), you would send the following SMS command to the

unit.

Text Command:

*CSQ?#

It is possible to check the system is operating correctly by sending the following SMS

command to the unit.

Text Command:

*TEST#

When the unit replies TEST-OK indicate the unit is operating correctly.

Note: If you receive no reply then unit is not working

To setup a password for reset command, you can send the following SMS command

to the unit.

Text Command:

*PAWO#XXXXXX

XXXXXX stands for 6 digits password: 123456 (Default)

Example:

To change the password to 654321, you would send the following SMS command to

the unit.

*PAWO#654321

To reset the unit, you can send the following SMS command to the unit.

Text Command:

*REST#XXXXXX

5.6.10 Checking the System is Operating Correctly

5.6.11 Setting the Password for Reset Command

5.6.12 Reset the WT-9001 (Method 1)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

Pas de commentaire

Witura WT-9001 IP65 Manuel d'utilisateur Page 25