Witura WT-9001 IP65 Manuel d'utilisateur télécharger pdf (Page 16)

WT-9001 IP65 GSM Remote Monitorin

& Remote Control S

stem

WT-9001 IP65 – USER MANUAL – Rev. 4.7 – Technical Support: [email protected]

WITURA CORPORATION SDN BHD

Note: This Function Works On Analogue Input Only

There are 4 alarm set points available on each analogue input. It allows the unit to

generate alarms whenever the monitored signal reaches the set point. To program the

alarm set points, you can send the following command by SMS to the unit.

Text Command:

*ALP[N][I]#XX,F

N stands for input number 1 – 4

I stands for set point number 1 – 4

XX stands for 2 digits Percentage Threshold Alert Value for Alarm

F stands for the perform functions (Selectable) 0 – 10

Selectable Functions (F) Description:

Function 0:

 No Function

Function 1:

 Activates output relay 5 to stay on

Function 2:

 Activates output relay 6 to stay on

Function 3:

 Activates output relay 7 to stay on

Function 4:

 Activates output relay 8 to stay on

Function 5:

 Sends a programmable alert message (*SDF[N]#)

Function 6:

 Sends a programmable alert message (*SDF[N]#) and activates audible alarm

(Depends on function *ALM#)

Function 7:

 Turn off output relay 5. The unit will send SMS if the relay 5 is ON at previous state.

If not it won’t send SMS.

5.4.3 Setting the Alarm Set Points for Analogue Input

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

Witura WT-9001 IP65 Manuel d'utilisateur Page 16